Renkus-heinz ICL-R User Manual download pdf (Page 28)

IC Live Users Manual - Models ICL-R & IC215S-R

CobraNet Signal Routing

CobraNet devices transmit and receive digital audio (48 or 96 kHz, 16, 20 or 24 bit) in bundles of up to 8 channels. The number of chan-

nels per bundle can vary, depending on latency and resolution settings. The number of bundles available depends on network bandwidth.

Each CobraNet bundle has a number from the following ranges:

0: Disables the receiver or transmitter.

1 thru 255: Multicast mode (many receivers can access the same bundle).

256 thru 65,279: Unicast mode (allows only one receiver to receive the bundle).

In order for CobraNet devices to communicate, their Tx (Transmit) and Rx (Receive) bundle numbers must match. RHAON software makes

this easy. In some cases the settings of a CobraNet source will have already been established with the source’s own proprietary software

and can be changed only with the manufacture’s software. However, if the manufacturer’s software allows it you can set or reset both

receiver and transmitter bundle settings of any device found on the CobraNet network using RHAON software.

The rst step in setting up CobraNet rout-

ing is to scan the network and then drag the

CobraNet Source that was detected by Scan

Network into the work space.

The CobraNet Source and the devices con-

nected to it must have the same Sample Rate

and Latency settings. Right clicking on the Co-

braNet Source Icon will open a pop up screen

showing the Sample Rate and Latency settings.

We suggest you accept the Source’s default

settings unless you have a specic reason to

change them.

You will then want to check the device set-

tings to make sure they are the same as the

Source’s settings. The settings must be the

same for the source and for all devices con-

nected to it.

While latency may be changed here via point-

and-click, the sample rate is pre-programmed

in the DSP rmware running in the loudspeaker.

You can switch the sample rate only by upload-

ing the appropriate rmware to the loudspeaker.

Please refer to page 52, “Updating DSP Firm-

ware” for information on how to upload new

rmware to your device.

Next, check the bundle settings of the Co-

braNet Source device. The Source in our ex-

ample has 4 Receivers and 4 Transmitters. The

red triangles on the left of its icon represent Rx

bundles and the green triangles represent Tx

bundles. Right clicking on one of the triangles

will open a pop up window that shows the

bundle number and allows you to change it.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Comments to this Manuals

No comments

Renkus-heinz ICL-R User Manual Page 28

Comments to this Manuals

Related products and manuals for Acoustics Renkus-heinz ICL-R